FUGALEIK is a colored powder designed to be mixed with water and to obtain a flowing, thixotropic and easily smoothing mortar for grouting tiles on floors and walls. the product has excellent water and weathering aging resistance and it is ideal for colored, hydrophobic grouts, without surface defects and with excellent color stability over time. FUGALEIK is proposed in a wide range of colors to allow architects and interior designers to always obtain the best combination of colors with the coverings used.
The product also allows sealing grouts from 0 to 5 mm in a very short time without causing finishing problems and cleaning the supports.
CLASSIFIED CG2WA ACCORDING TO THE EUROPEAN STANDARD EN13888.
|AVAILABLE FORMATS - FUGALEIK|
|FL5||5 KG||*BOX 4 X 5 KG|
|FL2||2 KG||*BOX 8 X 2 KG|
*On request the boxes can be provided on pallets
ADVICE FOR USE
Before starting to grout, remove spacers and debris in grout joints and remove dust and dirt using a wet sponge. For porous tiles and/or in hot weather conditions, wet the joints with clear water.
Pour 28-30% of water (calculated on the weight of the powder) into a clean container, add a bag of FUGALEIK under mixing and mix with a low-speed whisk drill for about 2 minutes until a creamy mixture is obtained. Leave to rest for 5 minutes and mix again for about 1 minute. The amount of water may vary depending on the color of the product and the desired consistency.
Fill the joints completely with FUGALEIK using a rubber float, making sure the joints are completely compacted. To remove excess grout pull the float diagonally across the joints to avoid pulling out the material. For first cleaning wait approximately 25-30 minutes at 23°C. Begin initial cleaning by lightly wiping down entire area to be cleaned with a damp sponge. Rinse the sponge frequently with clean water. Do not clean too early when the mixture is still plastic in order to avoid the grout dragged from the joint leading to colour variation. Allow to dry 3 hours for second cleaning.
Coverage of FUGALEIK varies depending on the width of the joints, the size and thickness of the tiles.
For professional use only.
Consult technical data sheet and safety data sheet before use.
Use between +5°C and +40°C.
Protect from moisture, store in a dry place.
wash with plenty of water.
rinse cautiously with water for several minutes.
remove contact lenses, if present and easy to do. Continue rinsing.
PORTLAND CEMENT- Cr (VI) < 2ppm, may produce an allergic reaction.
LEIK SPA - Via Alessandro Volta 10
46040 - Ponti sul Mincio - Mantova
Enhanced cementitious grout with high abrasion resistance and low water absorption